Basic HTML Version
~ u[l,~fMljO~
Pans Information
Lower Right Flipper
C-11626-R-3
. Lower Left Flipper
C-11626-L-3 Flipper Assembly Notes:
1 Each Flipper Assembly on the Lower Playfleld (and
the two Lower Flipper Assemblies on the Upper
Playfleld) Is mounted beneath the playfleld, In
conjunction with the plastic Flipper Paddle and Shaft
(20-9250-5) and flipper Rubber (23-6519-4) on the
upper side of the playfleld.
The Upper Flipper
Assembly on the Upper Playfleld uses a plastic
Flipper Paddle and Shaft (C-11927-5) and flipper
Rubber (23-6553-4).
2 The tp of the EOS Switch must travel 0.0150 (+ .010,
- .000) Inch, before the contacts fully open, with the
flipper In the actu- ated position. The EOS Switch
contacts must have a gap of 0.062 (± .015) Inch.
Adjustment of the EOS Switch must be made at a
minimum dl.anea of 0.25 Inch from the switch body.
3 not used
4 All moving elements of the assembly must operate
freely, with no evidence of binding.
5 The large end of the Coli Plunger SprIng (Item 12) must
fit within the four lugs of the Solenoid Bracket.
S For coli replacement, remove the Solenoid Bracket
(Item 11) to prevent screw damage.
7 Use LoatlteD( 242 when reattaching screws to the
FJw-r Stop Assembly, the Solenoid Bracket, and the
FIpper Bushing.
e
When replacing the Bumper Plug (Item 14) to restore
proper flipper operation, readjust the flipper paddle
and shaft position.
9 Solid color blue wire connects to the banded end of
each diode, mounted on the connector end of the
FJw-r ColI (Item 9). Trace color wire conneeta to the
unbanded end of the diode.
5-6
•
•
••
•
•