Messages

1

MMR Support [MMR Members Only] / Re: MMR insert text is thin and transparent

« on: February 10, 2016, 06:22:06 PM »

The white inserts at the bottom are definitely the worst. I cannot read any of the text lit or not lit. It looks cheap. I assume they cannot be replaced easily and I don't want to replace the board myself.
I have the old generation game at some friend and the inserts look a lot better! I will try and post some shots.

2

MMR Support [MMR Members Only] / Re: Tilt not working

« on: February 10, 2016, 02:06:06 PM »

Thank you Taylor and Lloyd!


I moved the tilt bob during the switch tests and it does register so am guessing this is all good then. I will try and tilt the game for good next

3

MMR Support [MMR Members Only] / Tilt not working

« on: February 08, 2016, 01:03:51 AM »

Hello,


I received my MMR LE Black and installed this week-end and loving it.


Tilt is not working and I did not change the settings. I added the weight piece to the bar where it is supposed to fit. When I powered the game for the very first time and it was running tests,  I got an error message about tilt  and it being locked but I unfortunately did not write it down. Restarting the game a second time brought it up fine but I don't believe tests were running again.


Is there a way to re-run the same tests? I went through the systems menus and could not find it.


Is there a specific test to check the Tilt mechanism?


Thanks for any help,


--Frank

4

MMR Support [MMR Members Only] / Re: MMR insert text is thin and transparent

« on: February 07, 2016, 11:32:35 PM »

I just got my MMR LE Black game installed this week-end and I love it but the inset text issue is very much present. My room does not have much light and therefore no direct Sun exposure but it is pretty much impossible to read anything on the inserts when lit (especially at the bottom). They do look very cheap IMO.

5

MMR Support [MMR Members Only] / Re: Volume control question

« on: February 07, 2016, 01:09:31 AM »

Sorry but how do you get to adjustment menu?

I'd like to reduce the volume below level 8 and therefore do the override mentioned above.

EDIT: Never mind, found it on page 1-13 of the manual:
"To access the Main Menu open the coin door, press the Begin Test button, then the Enter button.Press the Up and Down buttons to scroll through the Main Menu. To access a menu, (Bookkeeping,Printouts, etc.), from the Main Menu, press the Enter button. To return to the Main Menu (fromBookkeeping, Printouts, etc.) press the Escape button. Press the Start button for HELP."
Cheers