• December 21, 2024, 07:37:38 AM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wolfman1138

Pages: [1]
1
MMR Support [MMR Members Only] / Re: Check your flipper coil screws and bolts for security
« on: June 13, 2016, 02:37:51 PM »
Hahha.  I just got done rebuilding my left flipper too. 
Same exact scenario of the allen bolt falling out.  I never found the lock washer either, so that may also have been a contributing factor.
My "rebuild" came about because I accidentally cross threaded the lock nut and then sheared the bolt trying to disassemble it. *sigh*


It seems to be fixed now, but it was a mess.

2
MMR Support [MMR Members Only] / Re: Issues with the left "Peasant" Ramp lift
« on: September 14, 2015, 08:09:53 PM »
I took everything apart and have tried to rebend the ramp.  It seems to sit flush for now, so we will see how it goes.  It took several tries to get it flat.

3
MMR Support [MMR Members Only] / Issues with the left "Peasant" Ramp lift
« on: September 09, 2015, 02:29:17 PM »
Hi Folks,


I have an issue with the Ramp edge of the left Peasant ramp.  The metal flap if lifting on the left edgeand causing the ball to bounce up and subsequently is denting the playfield.  It is frustrating because it blocks the ramp on the left side and slows the right side shots enough that we often don't make the ramp.


I have included a picture I took with the glass still on.  Not the best, but you can easily see the left edge lifting.


I will admit that I am a pinball machine noob, and MMR is my first machine.  So be gentle. :)


I tried loosening the ramp and gently re-bending the ramp flap, but it seems to just return to the normal position.  I also tried a piece of double sided tape (10lb stuff from 3M) back from the edge.  This held it down flush for a few days, but did not keep it in place.


If you have any advice on how to fix this, I'd be most grateful!


Thanks in advance. 

4
MMR Support [MMR Members Only] / Re: MMR Sound Issue
« on: September 09, 2015, 01:34:20 PM »
I also get the same sound issue.  My game is #301 and it was manufactured beginning of August.
The software bootup screen says 50059  Rev. 1.0

Pages: [1]