Messages

1

MMR Support [MMR Members Only] / Re: Coin mechs ? What is needed .

« on: April 24, 2015, 07:34:00 AM »

I installed coin mechs in my MMR last night (purchased from PPS) and while I eventually got them installed I had to completely re-route a significant portion of the coin door harness that was run right across the middle of the door causing a mechanical interference.  Its working (at least one in, one reported issues and may need tweaking) but this is something that seriously needs to be changed at the factory during assembly.

2

MMR Support [MMR Members Only] / Re: MMR Sound Issue

« on: April 19, 2015, 12:08:03 PM »

I re-seated the speaker connector on the lower right of the controller board in the back box and that seemed to fix it.

3

MMR Support [MMR Members Only] / MMR Sound Issue

« on: April 18, 2015, 10:49:01 AM »

My MMR is in and I'm LOVING it.  Its been on for 3 days straight as a burn in and I've started noticing noise/popping sounds in the audio.  There are deterministic and repeatable and to be honest, pretty annoying.  This machine is destined for a location so its not a show stopper but I thought I'd check for a cause/solution before I popped the hood and started poking around.

Any suggestions?  Has anyone else seen this?   

Thanks,

Jeff S.