• December 26, 2024, 06:53:17 AM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.
« previous next »
Pages: [1]   Go Down

Author Topic: Castle Drawbridges Error message says "Down switch broken"  (Read 15191 times)

Offline styxskum

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 4
  • Karma: +0/-0
    • View Profile
Castle Drawbridges Error message says "Down switch broken"
« on: July 13, 2016, 09:01:23 PM »
My machine is giving me an error message that the up and down switches are broken.  when i go into the switch test mode and operate the manually nothing happens the do not close they stay in the open position. Both switches stay open. help
Logged

Offline Lloyd Olson

  • LTG : )
  • Global Moderator
  • Three Star Member
  • *****
  • Posts: 385
  • Karma: +18/-7
    • View Profile
Re: Castle Drawbridges Error message says "Down switch broken"
« Reply #1 on: July 13, 2016, 09:41:57 PM »
Please check connector for the switches close to the drawbridge assembly that it is pushed together tight, and a wire or pin isn't sticking out. Then follow to the board the wires go to and be sure that connector is plugged on tight.

In Tests, you can also run a drawbridge test to check them.

LTG : )
Logged
Pages: [1]   Go Up
« previous next »