Tilt not working

[Fibonaccov]

Hello,


I received my MMR LE Black and installed this week-end and loving it.


Tilt is not working and I did not change the settings. I added the weight piece to the bar where it is supposed to fit. When I powered the game for the very first time and it was running tests,  I got an error message about tilt  and it being locked but I unfortunately did not write it down. Restarting the game a second time brought it up fine but I don't believe tests were running again.


Is there a way to re-run the same tests? I went through the systems menus and could not find it.


Is there a specific test to check the Tilt mechanism?


Thanks for any help,


--Frank

[TaylorVA]

Go into switch test and physically move the tilt bob over to make contact. Should register.

[Lloyd Olson]

Please check that the brass ring and plumb bob are clean to make good electrical contact. Then follow the wires to be sure something didn't come unplugged.

LTG : )

[Fibonaccov]

Thank you Taylor and Lloyd!


I moved the tilt bob during the switch tests and it does register so am guessing this is all good then. I will try and tilt the game for good next