Medieval Madness Remake (MMR) > MMR Support [MMR Members Only]

Coin mechs ? What is needed .

(1/2) > >>

Boxedbeef:
Awaiting my Gold LE , possibly next week . What coin mechs do I need to buy ? Just the Suzo Happ .25 cts ? Plus mounting brackets or ? Just want everything ready set go !

Lloyd Olson:
Any 25 cent mech will work. I prefer the metal ones. There are three holes on each side, and usually come with two studs screwed into those holes each side. For the coin door on MMR, with the mech facing you, you don't need any studs on the right side of the mech, and on the left side you need studs in the top and bottom holes only.

All you need is the mech. On the coin door all the mounting stuff is there. Lift the plastic flap up, snap the mech in - flat side to the coin door and stud side to the outside. Lower the plastic flap so it hooks the studs, and you are good to go.

LTG : )

Boxedbeef:
Thanks Loyd , your the best ! You have helped me previously with my other preorder game .
Thrilled to see you pitching in on the MMR as well .
Paul , Miami . fl.

sandersj:
I installed coin mechs in my MMR last night (purchased from PPS) and while I eventually got them installed I had to completely re-route a significant portion of the coin door harness that was run right across the middle of the door causing a mechanical interference.  Its working (at least one in, one reported issues and may need tweaking) but this is something that seriously needs to be changed at the factory during assembly.

Pablito:
Ughh I plan on installing them too. Thought it would be a snap. Rerouting a wiring harness sounds like a pain in the ass. Hopefully Rick can bubble that up to Doug and Stern to make the change.

Navigation

[0] Message Index

[#] Next page