• November 12, 2024, 07:26:56 PM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Author Topic: Coin acceptor for MMR  (Read 18055 times)

Offline PinDuo

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 7
  • Karma: +0/-0
    • View Profile
Coin acceptor for MMR
« on: July 16, 2016, 05:21:41 PM »
What type of coin acceptor can be put in the MMR?

Offline schonb25

  • PPS Forum Member
  • Two Star Member
  • *
  • Posts: 74
  • Karma: +5/-11
    • View Profile
Re: Coin acceptor for MMR
« Reply #1 on: July 16, 2016, 05:30:04 PM »
You are not allowed to view links. Register or Login

Offline PinDuo

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 7
  • Karma: +0/-0
    • View Profile
Re: Coin acceptor for MMR
« Reply #2 on: July 17, 2016, 10:28:18 AM »
Thanks,
I use it as my bank for pinball repairs and parts.
Gotta pay to play

Offline Rick7775

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Re: Coin acceptor for MMR
« Reply #3 on: July 25, 2016, 10:34:20 AM »
OK... I'm a bit confused about this. I purchased two of these coin mechanisms for MMR (they're not too expensive so I thought it would be a good way to control how much the children play). When I went to install them, I discovered that the wiring harness for the game menu system runs right through the area where these should install. With the wiring there, there is no way to install the coin mechanism. I'm a bit concerned about cutting wiring mounts and trying to re-route all the wiring.

Has anyone done this? Is there any way to do it without simply leaving the wires hanging?

I need some help here.

Thanks

Offline Lloyd Olson

  • LTG : )
  • Global Moderator
  • Three Star Member
  • *****
  • Posts: 385
  • Karma: +18/-7
    • View Profile
Re: Coin acceptor for MMR
« Reply #4 on: July 25, 2016, 04:10:59 PM »
I cut the cable ties holding my wiring to the door and was able to move/position the wires enough to get the mechs in.

LTG : )

Offline Boxedbeef

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 29
  • Karma: +0/-0
    • View Profile
Re: Coin acceptor for MMR
« Reply #5 on: July 26, 2016, 10:36:17 PM »
I did same thing , Loyd had advised me previously and both mechs fit fine without cutting anything !